M1 (Pwm1 Duty Cycle); Associate Led Blink Time); Rp (Rssi Pwm Timer); I/O Sampling Commands - Digi XBee 868LP User Manual

AT commands

M1 (PWM1 Duty Cycle)

The duty cycle of the PWM1 line (pin 8).
Use the P1 command to configure the line as a PWM output.
Parameter range
0 - 0x3FF
Default
0
LT (Associate LED Blink Time)
Set or read the Associate LED blink time. If you use the D5 command to enable the Associate LED
functionality (DIO5/Associate pin), this value determines the on and off blink times for the LED when
the device has joined the network.
If LT = 0, the device uses the default blink rate: 500 ms for a sleep coordinator, 250 ms for all other
nodes.
For all other LT values, the firmware measures LT in 10 ms increments.
Parameter range
0x14 - 0xFF (x 10 ms)
Default
0

RP (RSSI PWM Timer)

The PWM timer expiration in 0.1 seconds. RP sets the duration of pulse width modulation (PWM) signal
output on the RSSI pin.
When RP = 0xFF, the output is always on.
Parameter range
0 - 0xFF (x 100 ms)
Default
0x28 (four seconds)

I/O sampling commands

The following AT commands configure I/O sampling parameters.

AV (Analog Voltage Reference)

The analog voltage reference used for A/D sampling.
Parameter range
0 - 2
0, 1
XBee 868LP RF Modules User Guide
I/O sampling commands
155