Set Up And Perform A Range Test - Digi XBee 868LP User Manual

Get started
6. Select XBEE_A and click the Discover radio nodes in the same network button
7. Click Add selected devices in the Discovering remote devices dialog. The discovered remote
device appears below XBEE_A.
8. Select the remote device XBEE_B, and configure the following parameter:
LT: FF (hexidecimal representation for 2550 ms)
9. Click the Write radio settings button
The remote XBee device now has a different LED blink time.
10. To return to the default LED blink times, change the LT parameter back to 0 for XBEE_B.

Set up and perform a range test

This section shows you how to set up two XBee modules to perform a range test, which demonstrates
the real-world RF range and link quality between two XBee modules in the same network. Performing
a range test gives an initial indication of the expected communication performance of the kit
components. When deploying an actual network, perform multiple range tests to analyze varying
conditions in your application.
Configure the devices for a range test
For devices to communicate with each other, you configure them so they are in the same network.
You also set the local device to API mode to obtain all possible data of the remote device.
XBee 868LP RF Modules User Guide
Do more with your XBee modules
.
.
49