Detailed Explanation - Hitachi HIDIC EH-150 Applications Manual

10.3 Detailed Explanation

10.3.1 Error Code
Error code
00
01
02
03
06
10.3.2 Active Node
Node addresses of the slaves registered in the scan list of the EH-RMD are displayed.
10.3.3 Faulty Node
Among the slaves registered in the scan list of the EH-RMD, the node addresses of those that cannot be
communicated with are displayed.
10.3.4 Node Status
Value Description
0x00 OK or Not in scan list
0x46 DUP_MAC_FAILURE
0x47 SCANNER_CONFIG_ERROR
0x48 DEVICE_COMM_FAILURE
0x49 WRONG_DEV_TYPE
0x4A PORT_OVERRUN_ERROR
0x4B NETWORK_FAILURE
0x4C NO_MESSAGE_FOR_SCANNER
0x4D WRONG_SIZE_DATA
0x4E NO_SUCH_DEVICE
0x4F TRANSMIT_FAILURE
0x50 IN_IDLE_MODE
0x51 IN_FAULT_MODE
0x52 FRAGMENTATION_ERROR
0x53 SLAVE_INIT_ERROR
Table 10.1 List of Error Code
Description
No error
Initialization error
Link transmission area error
Link transmission size error
Module error
Table 10.2 List of Node Status
Chapter 10 Special Internal Outputs
Action
―
Turn the power on again. Replace the module if
the error still persists.
Set the link parameters again from the
peripheral device.
Turn the power on again. Replace the module if
the error still persists.
Node Description
0x54 NOT_YET_INITIALIZED
0x55 RECEIVE_BUFFER_OVERFLOW
0x56 DEVICE_WENT_IDLE
0x57 SHARED_MASTER_ERROR
0x58 SHARED_CHOICE_ERROR
0x59 KEEPER_FAILED
0x5A CAN_PORT_DISABLED
0x5B PORT_BUS_OFF
0x5C PORT_POWER_OFF
0x5F FLASH_UPDATE_IN_PROGRESS
0x60 IN_TEST_MODE
0x61 HALTED_BY_USER_COMMAND
0x62 FIRMWARE_FAILURE
0x63 SYSTEM_FAILURE
― ―
10-3