Hitachi HIDIC EH-150 Applications Manual page 59

Chapter 8
In the configuration method of EH-RMD, it is mentioned the case of using Rockwell Automation configurator.
Please refer to the "DeviceNet master configuration software application manual (NJI-455)" for using Hitachi
configurator.
No. Product name
1 RSNetWorx™ for DeviceNet 9357-DNETL3
No. Product name
1 PC Serial Interface
2 PCMCIA Interface Card
3 PCI Scanner Card
Use one of the interface modules above.
The products mentioned above are provided by Rockwell Automation.
• Please contact the following to obtain more information about the purchase and specifications of the
above-mentioned products.
http://www.automation.rockwell.com/
The local office in every country can be accessed from the above site.
•
Please contact the following to obtain information about the installation and operation method of the
above-mentioned products.
http://www.automation.rockwell.com/support/
For information on the EH-RMD and PLCs in general, please contact the Hitachi dealer where you made the
purchase.
This chapter explains the steps necessary in order to start up the system for the first time, using the flow chart
shown below.
See the manual packaged with each product for the software installation method and other relevant details.
Start
Setup on the PLC side
TM
Startup of RSLinx
Setting of the driver (see Note)
Startup of RSNetWorx TM
Registration of the EDS file
Registration of the device
Creation of a scan list
Download
End
(Note) This manual explains the case where a
Starting Up
Table 8.1 Configuration software
Type
Table 8.2 Interface modules
Type
1770-KFD
1784-PCD
1784-PCID
PC Serial Interface
Specification
Runs on Windows® 95/98 and Windows NT® 4.0.
This application is an English version.
Specification
Uses a serial port.
Uses an IC card interface.
Uses a PCI bus slot.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
is used as the interface module.
8-1
Chapter 8 Starting Up
Once the driver is set, it is not necessary to
change it in these steps, unless the interface
module or communication speed is changed.