Canon JX500 Service Manual page 88

6-2-2 Assembly of Outside Appearance
Assemble in the reverse order of disassembly.
If the main case unit is not installed due to the tilt of the pressing plate unit, rotate
the paper feed motor to any direction. Tip up pressing plate unit. Install the main
case unit.
Never touch the timing slit disk film.
6-2-3 Outside Appearance Cable Wiring
Fig.Part 1-20 Outside Appearance Cable Wiring
Fig.Part 1-21 Outside Appearance Cable Wiring
1: The PGC Sensor Board ass'y cables
and Speaker ass'y cables
2: Tape attachment position of
the PGC Sensor Board ass'y cables
1: The PGC Sensor Board ass'y cables
2: The Speaker ass'y cables
3: Lead cables to the metal groove.
Part 1 - 80