Respironics BiPAP Plus User Manual page 35

p
roBlem
You are having problems
connecting the tubing to the
device.
You are experiencing excessive
air leaks where the tubing
connects to the device.
The air out of the mask is much
warmer than usual.
B pap p m s u
I lus erIes
W I h
hy t
You have lost the
air outlet port or are
traveling and forgot
to bring the port with
you.
The air outlet port is
not installed correctly
and doesn't seal
properly.
The air filters may be
dirty.
The device may be
operating in direct
sunlight or near a
heater.
m
ser anual
appened
If you are not using a humidifier, you cannot connect your
tubing to the device without the detachable air outlet port,
shown below.
You must have the port attached properly before
connecting your tubing.
Remove the port and reattach it to make sure it's properly
installed.
To remove the port:
a. Put your thumb underneath the port and insert your
index finger into the port opening.
b. Pivoting from the bottom, unsnap the port and pull it
away from the device.
To properly reattach the port:
a. Make sure it is correctly oriented (with the port
opening at the top), and insert the two latches at the
bottom of the port into the openings on the bottom
of the device.
b. Push the top of the port down to snap it into place.
Reattach your tubing, turn on the airflow, and check to
make sure you do not still feel air coming out of the port
area.
Clean or replace the air filters as described in Chapter 7.
The temperature of the air may vary somewhat based
on your room temperature. Make sure that the device is
properly ventilated. Keep the device away from bedding or
curtains that could block the flow of air around the device.
Make sure the device is away from direct sunlight and
heating equipment.
If the problem continues, contact your home care provider.
W d
hat to o
5-5