Respironics BiPAP Plus User Manual page 19

Note: If required, connect a bacteria filter to the device air outlet, and then connect the
flexible tubing to the outlet of the bacteria filter.
2. Connect the tubing to the mask:
a. If you are using a mask with a built-in exhalation port, connect the mask's connector to
the flexible tubing, as shown in Figure 3–4.
b. If you are using a mask with a separate exhalation device, connect the open end of the
flexible tubing to the exhalation device as shown in Figure 3–4. Position the exhalation
device so that the vented air is blowing away from your face. Connect the mask's
connector to the exhalation device.
Warning:
Warning:
3. Attach the headgear to the mask. See the instructions that came with your headgear.
B pap p m s u
I lus erIes
f 3–3 C
Igure
f
Igure
The exhalation device (e.g., Whisper Swivel II) or exhalation port (on masks
with an integrated exhalation port) is designed to exhaust CO
circuit. Do not block or seal the ports on the exhalation device.
If you are using a full face mask (i.e., a mask covering both your mouth and
your nose), the mask must be equipped with a safety (entrainment) valve to
minimize the potential for CO
m
ser anual
Detachable
f
onneCtIng the lexIBle
3–4 C m
onneCtIng a asK
rebreathing.
2
Swivel
t
uBIng
from the patient
2
3-3