Omron EQUO Series User Manual page 78

The range of selection (Numeric input):
0.1 to 19.9%
Initial value:
0.6%
Note
 The LOCUT setting is not possible when ETC is set to "OFF" and DTAIL is also set to "OFF".
Measurement Range (RANGE)
(31)
Specifies the measurement range.
The range of selection (Options):
NORM / AUTO
Setting Value
NORM
AUTO
Initial value:
AUTO
Note
 The table below shows the resolutions (reference values) under AUTO setting.
* The reference value indicates a typical value, not a guaranteed value.
CT rating
5A
50A
100A
200A
The measurement range cannot be specified when ETC is OFF and DTAIL is OFF.
Rate/CO Conversion Value Setting (RATE)
(32)
2
Specifies the electricity rate or CO
The range of selection (Numeric input):
00.000 to 99.999
Initial value:
0.000
Note
 The rate/CO conversion value setting is not possible when ETC is set to "OFF".
2
(33) Conversion Unit Setting (CONV)
Specifies the unit for the rate/CO
The range of selection (Options):
JPY (Japanese yen) / USD (US dollar) / EUR (Euro) / CNY (Chinese yuan) / KRW (Korean won) /
CO (CO emission level per 1kWh)
2 2
Initial value:
JPY
CTX21
The measurement range is fixed.
The measurement range is automatically switched with approximately
5% or less of the CT rated current.
Approx. more than 5%
0.1A
1.0A
2.0A
4.0A
emission level per 1kWh.
2
conversion setting (RATE).
2
4-19
3. Check and Preparation
Operation
Approx. 5% or less
0.007A
0.063A
0.125A
0.250A