<Three-phase Four-wire>
Power Supply Side (K)
Load Side (L)
(3) When using ZN-CTX-A, connect it with the separately sold branch cable,
ZN-CTM11-C. Now, the connector position of the branch cable used must match the phase &
wire type of the circuit measured.
Detailed view of branch cable connector
Sensor head connector
• Single phase 2-wire
Power supply side (K)
Branch cable
connector
position
Load side (L)
Important
Take extra caution against electric shock.
Do not insert or remove the sensor head to/from the connector when the measurement
target is clamped.
The unit power must be ON when clamping a measurement target.
Branching/Fixing Hook
Branch cable connector
Separately sold branch cable (ZN-CTM11-C)
• Single phase 3-wire/3-phase 3-wire
Power supply side (K)
(Single-phase 3-wire)
(3-phase 3-wire)
Branch cable
connector
position
Load side (L)
3-29
3. Check and Preparation
• 3-phase 4-wire
Power supply side (K)
Branch cable
connector
position
Load side (L)