Omron EQUO Series User Manual page 46

(3) Changing IP Address (from factory default: 192.168.0.20 to 192.168.0.21)
Display
(Upper/Lower)
IP
DISP
↓
▼ or ▲ Key
IP 1
192
↓
▼ Key
IP 2
168
↓
▼ Key
IP 3
0
↓
▼ Key
IP 4
20
↓
SET/REC/STOP Key
IP 4
020
↑ Blinking
↓
▼ Key
IP 4
021
↑ Blinking
↓
SET/REC/STOP Key
IP 4
21
↓
▼ Key
Check that SUB1 to SUB4 are set to 255, 255, 255 and 0 respectively and apply them in the
same way as the procedure above.
After the settings for IP 1 to IP 4 and SUB1 to SUB4 are completed, press the MODE key.
"RESET" is displayed and the unit resets itself.
Display the first segment of the IP address. Press the ▼ or ▲ key until
"P 1" appears at the upper row.
Check that "192" is displayed at the lower row, and press the ▼ key.
If "192" is not displayed, change the value referring to the changing "IP
4" example shown later.
Check that "168" is displayed at the lower row, and press the ▼ key.
If "168" is not displayed, change the value referring to the changing "IP
4" example shown later.
Check that "0" is displayed at the lower row, and press the ▼ key.
If "0" is not displayed, change the value referring to the changing "IP 4"
example shown later.
Press the SET/REC/STOP key to change the value displayed at the
lower row to "21".
The value starts blinking. Press the ▼ or ▲ key to change the value to
"21".
Press the SET/REC/STOP key to apply the value. Blinking stops.
To check or change the subnet mask, press the ▼ key to display "SUB1"
at the upper row.
3-17
3. Check and Preparation
Operation