Omron EQUO Series User Manual page 74

Others (ETC)
(20)
Specifies if the unit displays the items for setting file read/write, time setting, and network
setting.
Setting range:
OFF / DISP
The items displayed by the setting value are as follows.
Setting data reading
Setting data writing
Time setting
Network setting
IP address setting
DTAIL
Charge/CO2 converted value setting
Setting of converted value unit
Unit number offset
The following item appears when the ▼ key is pressed after the setting is applied with the
SET/REC/STOP key.
Setting Value
OFF
DISP
Initial value:
OFF
Note
 The ETC setting returns to "OFF" when the unit is reset.
(21) Reading Setting Data (RESTR)
Restores the unit settings by using the SD memory card with the setting data saved as a
backup using the BCKUP setting (described later).
Operation:
Insert the SD memory card containing the setting data, and hold the SET/REC/STOP key.
Reading is completed when "DONE" is displayed.
The unit resets itself and restarts when the MODE key is pressed to change the operation
mode.
Note
 Only one setting data item (the setting data for only one unit) can be stored in a single SD
memory card as a backup.
 The setting data backed up in a unit can be restored on other unit.
 Setting data reading is not possible when ETC is set to "OFF".
Item
CTX21
CLEAR
RESTR
4-15
Setting Value
OFF
CTX21
No
No
No
No
No
No
No
No
No
Item
KMX21
CYCLE
CYCLE
3. Check and Preparation
DISP
KMX21
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
Yes No
Yes Yes
Yes Yes
No Yes