5.6
SD Outputting File to SD Memory Card
Recorded data can be output to SD memory card files when any of the following cases happen.
(1) The SET/REC/STOP is pressed (for less than 3 seconds) during recording. Recording in
the internal memory continues.
(2) The SET/REC/STOP key is held (for 3 seconds or longer) during recording. Recording in
the internal memory stops.
Refer to: 5.4.2Stopping Recording
(3) The internal memory becomes full during recording. Recording in the internal memory
continues. (The recording mode must have been set to "Continue mode".)
Refer to: 4.2.4(11) Recording Mode (REC)
(4) The SET/REC/STOP key is pressed (for less than 3 seconds in RUN mode) during
non-recording process, when recorded data remains in the internal memory. This refers to
the case that the unit restarts after it is reset during recording due to a power failure or
other reason.
(5) The Power Startup REC Restoration function (REREC) is set to ON, and the unit restarted
after a power failure during recording. Recording will start automatically after completion of
file output. If a file output failed, an error occurs and recording will not start.
Reference: 4.2.4(35) Power Startup REC Restoration (REREC)
5. Measurement and Recording (Unit Operation)
5-11