Specifications Introduction; Timing Parameters; Common Specifications - HP 8112A Operating, Programming And Servicing Manual

Specifications
Introduction

Timing Parameters

Common Specifications

All specifications in the following sections describe the warranted
performance of the instrument:
•
Timing parameters
•
Output parameters
•
Waveform characteristics
All specifications apply with a 50 n load, after a 30 minute warm-up
period, and are valid for ambient temperature in the range 1 5°C to
35°C. Refer to the General Characteristics section of this chapter for
the performance derating factor to be used outside this temperature
(
range within the specified operating range of 0°C to 55°C
All operating characteristics given in the following sections describe
typical performance figures which are non-warranted:
•
Trigger modes
•
Control modes
•
Output Modes
•
Inputs and Outputs
•
Additional features
•
General characteristics
Unless otherwise stated, specifications are quoted for 503 amplitude
in normal mode, fastest transitions.
Resolution
3 digits, best case 1 00 ps
Accuracy
± 53 of programmed value ±2 ns
Repeatability
Factor 4 better than accuracy
Jitter
max 0.2% of programmed value + 100 ps
2
)
.
Specifications 2-1