HP 8112A Operating, Programming And Servicing Manual page 37

Installation
Introduction
Safety
Considerations
Initial Inspection
Warning
This chapter provides installation instructions for the HP 81 12A. It
also includes information about initial inspection and damage claims,
preparation for use, packaging, storage and shipment.
The HP 81 12A is a Safety Class 1 instrument
exposed metal chassis that is directly connected to earth via the
)
power supply cable .
Before operation review the instrument and manual, including
the red safety page, for safety markings and instructions. These
must then be followed to ensure safe operation and to maintain the
instrument in safe condition.
To avoid hazardous electric shock, do not perform electrical tests
when there are signs of shipping damage to any part of the outer
covers or panels.
Inspect the shipping container for damage. If the container or
cushioning material is damaged, keep it until the contents of the
shipment have been checked
been verified both mechanically and electrically.
The contents of the shipment should be as shown in the shipping
document plus any accessories that were ordered with the
instrument. Procedures for checking the operation of the instrument
are given in Chapter 8
If the contents are incomplete, mechanical damage or defect is
apparent , or if the instrument does not pass the operators checks,
notify the nearest Hewlett-Packard office. Keep the shipping
materials for carrier's inspection. The HP office will arrange for
repair or replacement without awaiting settlement.
for completeness and the instrument has
Performance Tests.
3
(
instrument with an
Installation 3-1