Set Up Primary - Cobalt Digital Inc COBALT Qube 3 User Manual

Appendix A: Using the LCD Console

Set up primary

To set up the primary network interface on the Qube 3:
1. On the LCD console, hold down the
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the
screen:
SELECT:
ADVANCED NETWORK
3. Press the
SELECT:
REVIEW SETTINGS
4. Press the
SELECT:
SETUP PRIMARY
5. Press the
6. Enter the IP address of the primary network interface using the arrow
buttons. The left and right arrow buttons move the cursor position to the left
or right. The up and down arrow buttons increase or decrease the digit at the
cursor position.
7. Press the
8. Enter the Netmask of the primary network interface using the arrow buttons.
9. Press the
10. Enter the Gateway using the arrow buttons.
11. Press the
12. Use the arrow buttons to toggle the cursor between [S]ave or [C]ancel.
13. Press the
If you select Save, the Qube 3 saves the new information. The LCD screen
returns to the normal display with the fully qualified domain name on the top line
and the IP address on the bottom line.
If you select Cancel, the LCD screen just returns to the normal display.
198
button until ADVANCED NETWORK appears in the LCD
button. The LCD screen displays:
button until SETUP PRIMARY appears in the LCD screen:
button.
button.
button.
button.
button.
Cobalt Qube 3 User Manual
button for approximately two