Advertisement
English
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
a) The ISM (industrial, scientific and medical) bands between 150 kHz and 80 MHz are 6,765 MHz to 6,795
MHz;13,553 MHz to 13,567 MHz; 26,957 MHz to 27,283 MHz; and 40,66 MHz to 40,70 MHz.
b) The compliance levels in the ISM frequency bands between 150 kHz and 80 MHz and in the frequency range 80
MHz to 2.5 GHz are intended to decrease the likelihood that mobile/portable communications equipment could
cause interference if it is inadvertently brought into patient areas. For this reason, an additional factor of 10/3 is
used in calculating the recommended separation distance for transmitters in these frequency ranges.
c) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site
survey should be considered. If the measured field strength in the location in which the device is used exceeds
the applicable RF compliance level above, the device should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as reorienting or relocating the device.
d) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
Recommended separation distances between portable and mobile RF
communications equipment and this device:
This device is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. The customer or the user of this device can help prevent electromagnetic interference by
maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and this device as recommended below, according to the maximum output power of the
communications equipment
Rated maximum
Separation distance according to frequency of transmitter m
output power
of transmitter
150 kHz to 80 MHz
W
d
1
2 .
P
0.01
0.12
0.1
0.38
1
1.2
10
3.8
100
12
For transmitters rated at a maximum output power not listed above, the recommended separation distance
meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects, and people.
80 MHz to 800 MHz
800 MHz to 2,5 GHz
d
1
2 .
P
d
2
3 .
P
0.12
0.23
0.38
0.73
1.2
2.3
3.8
7.3
12
23
14
Italiano
3. INSTALLAZIONE
Aprire la confezione controllare che siano contenuti tutti gli elementi.
Contenuto della confezione
Materasso x 1 (potrebbe non essere incluso se è stata acquistata solo la pompa)
Pompa x 1
Manuale d'uso x 1
Ispezionare l'attrezzatura e verificare che non sia stata danneggiata durante la spedizione. Se ci sono
dei danni, rivolgersi immediatamente al rivenditore.
3.1 INSTALLAZIONE DI POMPA E MATERASSO
1.
Collocare il materasso o imbottitura sopra la struttura del letto. Orientare il materasso in
modo che il disegno dei piedi, stampigliato sul
materasso, sia rivolto verso parte finale del letto
(dove sarà collocata la pompa).
2.
Collocare i ganci della pompa sulla ringhiera ai
piedi del letto. Tenere la pompa per la base e
girare i ganci verso l'esterno (o l'interno) per
fissarla alla ringhiera.
Se il letto non è dotato di ringhiere, collocare
la pompa su una superficie piatta e robusta,
oppure sul pavimento sotto il letto.
3. Collegare il connettore del tubo dell'aria (del
materasso ad aria) all'attacco della pompa. Il
collegamento è fissato in sicurezza quando si
sente uno "scatto".
NOTA:
i tubi dell'aria non siano piegati o infilati
d
in
sotto il materasso.
Controllare ed
assicurarsi che
95
Advertisement
