Install Software - Cisco Explorer Series Staging Manual

Install Software

Install the Application Platform Release
The next task that you must complete before you can stage DHCTs or CableCARD
modules is to install the current application platform software onto the DNCS.
Application platform software consists of the OS and ResApp software. The device
must have both of these components to function properly.
When the software is installed on the DNCS, the staging process then delivers the
software to the devices. Refer to Downloading New Client Application Platform Software
Installation Instructions.
Install the Current Resource File
If you are using the CVT download method to load the application platform
software onto devices, you need to make sure that you are using the most current
resource file (settop.res). This resource file contains information used by the CVT
configuration interface on the DNCS to validate the software for both DHCTs and
CableCARD modules to prevent loading the wrong software onto a device.
Refer to Downloading New Client Application Platform Installation Instructions (part
number 4003052) for more information about acquiring and installing the most
current resource files.
Install the OS Check Table (OSM Only)
If you are using the OSM download method to stage DHCTs, you must install the
OS check table.
Refer to Downloading New Client Application Platform Software Installation Instructions
for more information.
734375 Rev H

Install Software

19