Activating The Staging Toolkit For Dhcts With Single Or Triple Leds - Cisco Explorer Series Staging Manual

Activating the Staging Toolkit for DHCTs with
Single or Triple LEDs
Note: These instructions are for DHCTs with single or triple LEDs. For instructions
for DHCTs with full-display, alphanumeric LEDs, see Activating the Staging
Toolkit for DHCTs with Alphanumeric LEDs (on page 168).
You can activate the staging toolkit using either the remote control or the front panel
POWER button.
Activating the Staging Toolkit Using the Remote Control
1 On the remote control, press and hold the PAUSE button until the POWER LED
blinks.
2 As the POWER LED blinks, press the PAGE + button. The staging toolkit
activates and displays the DHCT diagnostic screens.
3 To page up and page down within the diagnostic screens, press PAGE +/PAGE
UP/NEXT + or PAGE -/PAGE DOWN/NEXT -, based on the type of remote
control you are using.
4 To exit the diagnostic screens, press the EXIT button on the remote control.
Activating the Staging Toolkit Using the POWER Button
1 Press and hold the POWER button until the POWER LED on the front panel
blinks, then release the POWER button.
2 While the LED is blinking, press the POWER button a second time. The POWER
LED should begin to blink quickly, and the diagnostic pages open.
3 To page up and page down within the diagnostic screens, press PAGE +/PAGE
UP/NEXT + or PAGE -/PAGE DOWN/NEXT -, based on the type of remote
control you are using.
4 To exit the diagnostic screens, press the EXIT button on the remote control.
734375 Rev H

Activating the Staging Toolkit for DHCTs with Single or Triple LEDs

169