Cisco Explorer Series Staging Manual page 50

Chapter 3 Optimize Your System Performance for Downloads and Staging
Change the Data Carousel Rates for an SR 2.5/3.5 and Later System
The instructions in this section guide you through the steps of editing the data
carousel rates (and related fields) on a system that supports SR 2.5/3.5/4.0 or later
system software.
Note: To edit the data carousel rates on a DBDS using a prior release, refer to
Recommendations for Data Carousel Rate Management Technical Bulletin (part number
716377).
Changing the Data Carousel Rates for the bootloader
Follow these instructions to change the data carousel rates.
1 From the DNCS Administrative Console, select the Application Interface
Modules tab.
2 Click BFS Admin. The BFS Admin Sites window opens.
Note: The system used in this example supports the Regional Control System
(RCS) feature that uses the DNCS to manage several remote headends. The
lionn1 site (shown in this example) is a remote headend. Your system may
support more remote headends or might not support the RCS feature at all.
40 734375 Rev H