Cisco Explorer Series Staging Manual page 127

Stage Alphanumeric
LED Indicator
5.
6.
7.
and then
8.
9.
10.
11.
734375 Rev H
POWER LED TV Monitor
Indicator
The light
blinks once
every half-
second.
The light
blinks twice,
pauses, then
repeats.
The light
blinks 3 times,
pauses, then
repeats.
The light is
off.
Solid on, then
off. The light
is off as the
DHCT boots
into the OS.
The light is
off.
For Service
Disconnect
(brick) mode,
the light
blinks eight
times, pauses
for half a
second, and
repeats.
LED Indicators Displayed During a CVT Download
Description
If the DHCT cannot acquire the CVT
through a recommended QAM frequency,
it 'hunts' until it finds the frequency of a
QAM with a valid CVT table for that
DHCT. The [000] indicates the QAM
frequency.
The LED displays r.xxx, where [xxx]
indicates the number of packets remaining
to be downloaded. This number counts
down to zero as the packets are
downloaded.
CLr and PR.00 indicate that the second
part of the OS is installed into flash
memory.
Programs upper memory area with
ResApp.
The wave appears after the DHCT resets to
boot into the OS and the newly
downloaded ResApp.
The rotating border appears when the
DHCT resets and boots into the OS.
The LED is clear when the OS has started
the ResApp. The DHCT is in an Off state.
If you use Service Disconnect (brick) mode,
go to stage 11 of this table.
If you do not use Service Disconnect
(brick) mode, go to stage 12 of this table.
The DHCT displays the Service Disconnect
mode indicator (if activated).
117