Manual Cleaning Method - Roland VersaUV LEC2-300 Regular Maintenance Manual

Manual Cleaning

Manual Cleaning Method

Be sure to perform manual cleaning after daily operations are finished. If you want to perform unmanned printing
at night, perform manual cleaning before sending the printing data.
CAUTION
CAUTION
IMPORTANT
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the print heads from drying out, finish this procedure in 10 minutes or less. A warning beep sounds
after 10 minutes.
• Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing
items may damage the print heads.
• Do not use cleaning liquid other than the included cleaning liquid.
• Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks will
adversely affect the printing results.
• Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate
the cleaning liquid.
• Never rub the print head surface (nozzle surface).
• Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
• If you use up the cleaning sticks or cleaning liquid, contact your authorized Roland DG Corporation dealer or
visit our website (http://www.rolanddg.com/).
If a warning beep sounds during cleaning
A warning beep sounds 10 minutes after operation begins. Stop work, close all the covers, and then
press [ENTER] to end the manual cleaning mode. After that, restart the procedure from the beginning.
Cleaning sticks
24
Do not perform cleaning immediately after printing has finished. (Wait
approximately 15 minutes after printing finishes.)
The area around the UV-LED device is hot and may cause burns.
Be sure to perform operations as specified by the instructions above, and never
touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Required item
Cleaning liquid
2.Regular Maintenance