Manual Cleaning Method - Roland TrueVIS SG2-640 Regular Maintenance Manual

Manual Cleaning Method

If the message "TIME FOR MAINTENANCE" is displayed or if dot drop-out or ink drip issues that cannot be im-
proved with powerful cleaning occur, perform manual cleaning.
Be sure to perform operations as specified by the instructions above, and never touch
CAUTION
any area not specified in the instructions.
Sudden movement of the machine may cause injury.
IMPORTANT
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the print heads from drying out, finish this procedure in 30 minutes or less. A warning beep sounds after 30 minutes.
• Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may damage the
print heads.
• Use only the included cleaning liquid.
• Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks will adversely affect the
printing results.
• Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the cleaning liquid.
• Never rub the print head surface (nozzle surface).
• Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
• If you use up the cleaning sticks or cleaning liquid, contact your authorized Roland DG Corporation dealer or visit our website
(
http://www.rolanddg.com/
If a warning beep sounds during cleaning
• A warning beep sounds 30 minutes after operation starts. Stop work, close all the covers, and then press [ENTER] to end the manual
cleaning mode. After that, restart the procedure from the beginning.
Cleaning sticks
1.
Clean the print head caps.
Procedure
1.
Remove any media.
2.
Press [FUNCTION].
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
CLEANING
MANUAL CL.
4.
Press [ENTER].
After "NOW PROCESSING.." is displayed, the screen shown below appears.
Also, the print head moves to the left end of the platen.
FINISHED?
IMPORTANT
Do not press the [ENTER] key at this stage. Press the [ENTER] key after cleaning is complete. If you press the [ENTER] key at this
stage, wait for the screen to change as shown in the following figure, and then press the [ENTER] key again.
).
Required items
Cleaning liquid
Manual Cleaning
2. Regular Maintenance
19