Cleaning The Machine; Cleaning The Media Path - Roland VersaUV LEC2-300 Regular Maintenance Manual

Cleaning the Machine

Cleaning the Media Path

Wipe away any ink or grime on the media path and other areas as part of the daily cleaning procedure. It is easy for
ink or grime to affix to the media path, and, if left unattended, this will contaminate new media and have a negative
effect on the transport of media when it is output. Pinch rollers, grit rollers, and the platen are particularly prone to
the buildup of grime.
WARNING
CAUTION
IMPORTANT
• This machine is a precision device and is sensitive to dust and dirt. Perform cleaning on a daily basis.
• Never attempt to oil or lubricate the machine.
Clean by wiping with a cloth moistened by neutral detergent diluted with water then wrung dry.
Pinch roller
Grit roller
Platen
10
Never use a solvent such as gasoline, alcohol, or thinner to perform cleaning.
Doing so may cause fire.
Before attempting cleaning, switch off the sub power and wait until the UV-LED
device cools (approximately 15 minutes).
Sudden movement of the machine may cause injury, or hot components may
cause burns.
These are the positions where the media is fixed in place or
transported, so it is easy for ink and grime to affix to these
positions. Failure to clean this part properly may result in the
transfer of grime to the surface of media.
These are the positions where the media is fixed in place or
transported, so it is easy for grime to affix to these positions.
Remove buildup of media scraps and other material using a
brush. Never use a metal brush.
Wipe away any buildup of ink, grime, or cut media on the
media path and in the grooves.
2.Regular Maintenance