Customization Basics; Side Panels; Refrigerator Location - Monogram ZISB36 Series Installation Instructions Manual

Design Guide - Stainless Steel Installation

CUSTOMIZATION BASICS:

Stainless Steel Wrapped Refrigerators
Stainless Steel wrapped refrigerators have wrapped
doors and grille panel, beveled edges, and tubular
stainless steel handles that coordinate with other
Monogram appliances. These models are shipped
ready for installation. These models do not include
handles.
Statement Handle
ZKSS2H2PNSS
Minimalist Handle
ZKSS2H2CNSS
*Optional Handles - When ordering this product, be
sure to use the model number associated with the
chosen handle.
31-1000450 Rev. 1

SIDE PANELS

Side panels must be used
whenever the sides of the
refrigerator will be exposed.
The 1/4" (0.63 cm) side panels
will slip into the side case
trim. Secure the panels to
the refrigerator with stick-on
hook and loop fastener strips.
Order the side panels from the
cabinet manufacturer.
• Cut a notch in the top front
corner as shown to allow
clearance for corner keys in
the front side trim.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
31
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
* Depending on installation height.