Important Information Before You Begin; Initial Systemaccess - SpectraLink IP-DECT Server 400 Installation And Configuration Manual

Chapter 1: Preface
This guide is intended for qualified technicians who will install, configure and maintain the
Spectralink IP-DECT Server 400 Solution.
This guide provides all the necessary information for successful installation and maintenance of
the Spectralink IP-DECT Server 400. For information about the installation and configuration of
the Spectralink DECT Repeaters and the Spectralink Handsets, please download the user guides
at www.spectralink.com.

Important Information Before You Begin

This guide assumes the following:
that users have a working knowledge of PBX operations
•
that the PBX is installed and initialized and is working correctly
•
that you have a working knowledge of deployment in general
•
that a site survey has been conducted and that the installer has access to these plans
•
Furthermore, you need the information in the following table below to enter the web based
Administration Page.
Table 1 Initial System Access
Initial System Access
Spectralink IP-DECT Server 400
IP address of the Spectralink
IP-DECT Server 400
User Name
Password
Note
The Spectralink IP-DECT Server 400 is pre-configured to use DHCP. If DHCP is not
available, it will fall back to static IP address (192.168.0.1) after one minute.
The current IP Address of the Spectralink IP-DECT Server 400 can be discovered using UPnP.
14219101 Version 3.0
August, 2013
DHCP assigned or 192.168.0.1 if
DHCP server is not available
admin
ip6000
1