Table of Contents
Advertisement
Chapter 5
Setting Up Discovery and Device Management
Step 7
Step 8
Import Devices
Note
Import Devices from a File
Step 1
78-16778-01
Set the CDP distance. If the distance is set to 1, only the immediate neighbors
b.
of the seed devices are discovered. Set the distance appropriately to discover
the entire wireless network.
Routers and switches that do not have access points attached to them
Note
are used when computing CDP distance. However, such devices will
not appear in the discovered devices list.
Click Next.
Click Finish to submit your changes. Discovery will begin at the scheduled time.
Click Back to make changes before submitting, or click Cancel to cancel all
changes.
For more information about scheduled discoveries, see the WLSE online help.
After you import devices, a one-time discovery job starts immediately. All of the
WLSE-supported devices in the file or found on the CiscoWorks server are used
as seed devices with a CDP distance of 1. After importing devices, ensure that
they are managed.
If CDP is not enabled and you import devices, only the imported access points and
wireless bridges will be discovered. Routers and switches will not be discovered.
Devices can be imported from a comma-separated values (CSV) file. You can
create the file by exporting devices from CiscoWorks RME or by creating a file
with a text editor. After you import the file, a one-time discovery begins
immediately.
Select Devices > Discover > Discover > Discovery Wizard.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Discovering Devices
5-11
Advertisement
Table of Contents
