Table of Contents
Advertisement
Installing WLSE 1130-19 Hardware
Installation Quick Reference
Installing the WLSE 1130-19 in a Rack
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
2-12
Connecting to the AC Power Source, page 2-25
•
Connecting Cables, page 2-25
•
Powering On the WLSE, page 2-26
•
Table 2-1
provides a high-level overview of the installation process. After
installation is complete, follow the directions in
WLSE."
Table 2-1
Quick Reference
Task
Use the rack mount kit to install
the WLSE in a rack.
Connect the WLSE to an AC
power source.
Connect network and console
cables.
Power on the WLSE.
Before installing the WLSE in a rack, read
page 2-7
to familiarize yourself with the proper site and environmental
conditions. Failure to read and follow these guidelines could lead to an
unsuccessful installation and possible damage to the system and components.
Perform the steps below when installing and servicing the WLSE.
The rack must be properly secured to the floor, to the ceiling or upper wall, and
where applicable, to adjacent racks. The rack should be secured using floor and
wall fasteners and bracing specified or approved by the rack manufacturer or by
industry standards.
Chapter 2
Installing WLSE 1130-19 Hardware
Chapter 3, "Setting Up the
References
Installing the WLSE 1130-19 in a Rack,
page 2-12
Connecting Cables, page 2-25
Connecting Cables, page 2-25
Powering On the WLSE, page 2-26
Preparing Your Site for Installation,
78-16778-01
Advertisement
Table of Contents
