Table of Contents
Advertisement
Chapter 3
Setting Up the WLSE
Step 6
Step 7
Changing the Configuration After Running Setup
Tip
78-16778-01
After you finish configuring the WLSE, it will reboot.
After the WLSE reboots, set up your mail server to send mail to external domains
by entering the following command:
mailroute {hostname | ip-address}
where hostname is the hostname of the SMTP server and ip-address is the IP
address of the SMTP server. If you do not set the mail server, email can only be
sent to the local domain. For more information about this command, see the User
Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.11.
You can also set up the mail server after you log in to the Web interface.
Note
See the online help or the User Guide for the CiscoWorks Wireless LAN
Solution Engine, Release 2.11.
To change the information in the setup configuration, use the following CLI
commands at any time. For more information about CLI commands, see the User
Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.11.
You can use CLI commands by connecting to the WLSE through the console or
by using Telnet or SSH. Log in initially as the admin user, using the password you
created during setup.
To change the host name, use the hostname command.
•
To change the domain name, use the ip-domain-name command.
•
To change the DNS server, or add up to 2 additional DNS servers, use the ip
•
name-server command.
To configure or reconfigure an Ethernet port, use the interface command.
•
•
To make changes in the HTTPS certificate, use the mkcert command.
To change any other part of the WLSE's initial configuration, use the erase config
command to erase the previous configuration, and rerun the setup program.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Configuring the WLSE's Network Information
3-5
Advertisement
Table of Contents
