Adding Device Credentials To The Wlse - Cisco CiscoWorks WLSE 1130-19 Installation And Configuration Manual

Adding Device Credentials to the WLSE

Adding Device Credentials to the WLSE
Note
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-2
Table 5-1 Quick Reference
Tasks
1. Add device credentials to the
WLSE.
2. (Optional) Set discovery and
management options.
Discover or import devices.
3.
Manage devices.
4.
Add any AAA servers to be
5.
monitored.
If you are importing devices, instead of discovering them, you may not need to
manually enter credentials. If you are importing devices from a file, the
credentials can be included in the file. If you are importing devices from
CiscoWorks RME, the credentials will be imported.
This section provides procedures for entering the following required device
credentials on the WLSE:
For all managed devices, enter SNMP credentials.
•
For access points, the following additional credentials are required:
•
For IOS-based access points, enter Telnet or SSH credentials and IOS
–
HTTP port settings.
For non-IOS access points, enter HTTP credentials.
–
For radio management, enter WLCCP credentials.
•
Chapter 5 Setting Up Discovery and Device Management
References
Adding Device Credentials to the WLSE,
page 5-2
Configuring Discovery Options, page 5-7
Discovering Devices, page 5-8
Managing Devices, page 5-13
Adding AAA Servers to the WLSE,
page 5-14
78-16778-01