Table of Contents
Advertisement
Please choose one of the following configurations:
1) CCA Manager.
2) CCA Server.
Only one CD is used for installation of the Clean Access Manager or Clean Access Server
Caution
software. You must select the appropriate type, either CAM or CAS, for the target
machine on which you are performing installation.
The Clean Access Server Package Installation then executes. The installation takes several
Step 8
minutes. When finished, the installation script presents the following message, prompting you
to press Enter to reboot the CAS and launch the Clean Access Server quick configuration
utility.
Installation complete. Press <ENTER> to continue
When finished, the welcome screen for the Clean Access Server quick configuration utility appears, and
a series of questions prompt you for the initial CAS configuration, as described in Run CAS
Configuration Utility Script, page 37.
6
Running the Configuration Utility
Once you have booted up the appliance, or if you have installed a new release on your Cisco NAC
Appliance, you are prompted to perform the initial configuration as described in this section.
• To configure the MANAGER, follow the steps in Run CAM Configuration Utility Script, page 33.
• To configure the SERVER, follow the steps in Run CAS Configuration Utility Script, page 37.
After completing initial configuration on both the MANAGER (CAM) and SERVER (CAS), continue
Accessing the CAM Web Console, page 45.
If you have previously installed and configured your CAM and are using this section to alter
Note
your current configuration, you can also launch the CAM configuration utility by logging in
to the CAM or CAS direct console and entering
information, see Manually Restarting the Configuration Utility, page 44.
32
service perfigo config
. For more
Advertisement
Table of Contents
