LEAB LPS Series User Manual page 25

Installation instructions
Error
Error Description
Code
E102 Current measurement
error (DC)
E103 Start error in power
supply unit
E104 Short-circuit in power
supply unit
E105 High-voltage error
E106 Error in power supply
control circuit
E150 Overload at AC output
E151 Peak current at AC output
lasts too long
E152 Peak current at AC output
is too high
E153, PE/N relay error
E254
E200, Charging current too high Contact your dealer to arrange a service.
E201
E202 High-voltage error
E203 Overload at AC output
E204, Error in transfer relay
E205
E206 High voltage
Overvoltage
Contact your dealer to arrange a service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Contact your dealer to arrange a service.
Reduce the load at AC output (230 V).
Reduce the load at AC output (230 V).
Reduce the load at AC output (230 V).
Contact your dealer to arrange a service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Contact your dealer to arrange a service.
Contact your dealer to arrange a service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Page 24 of 25
Troubleshooting
Solution