LEAB LPS Series User Manual page 13

Installation instructions
6. Secure the signal cable near the connection to the vehicle with a suitable
fuse (1 A ... 3 A).
7. Connect the open end of the signal cable to pin 9 of the D-Sub data
adapter.
8. Connect the D-Sub data adapter to the D-Sub plug on the device.
9. Plug the grey Anderson plug into the DC input (12 V) on the device and
screw it tight.
10. Connect the vehicle battery with the vehicle power circuit.
The device is connected.
Connecting the Consumer AC Output (230 V)
You have two options for connecting consumers to the AC output (230 V).

Consumer with Neutrik plug:
Insert consumer with Neutrik plug into the AC output on the back of the
device.
A Neutrik plug is included. You will find information on how to
install the plug on page 9.

Consumer with two-pin earthed plug:
Plug consumer with two-pin earthed plug into the AC output on the front
of the device.
The consumer is connected.
Connecting the Consumer DC Output (12 V)
To connect consumers to the DC output (12 V), perform the following steps:
1. Insert the red Anderson plug of the consumer into the DC output of the
device.
An Anderson plug is included. You will find information on how to
install the plug on page 9.
The consumer is connected.
Page 12 of 25
Installation