LEAB LPS Series User Manual page 24

Installation instructions
Error
Error Description
Code
E020, Error in inverter
E021
E022 Error in charger
E030, No calibration
E040
E049 Communication error at
input and output (DC)
E050 Cell voltage
measurement error
E051 Battery empty
E052, Cell voltage is too low
E053
E054, Cell voltage is too high
E055
E056, Cell temperature is too
E057 low
E058, Cell temperature is too
E059 high
E060 Battery voltage too low
E090 Input voltage (DC) is too
low
E091 Input voltage (DC) is too
high
E092 Input charging
current (DC) is too high
E094 Error in output relay
make contact (DC)
E095 Error in output relay
break contact (DC)
E096 Charging current at
output (DC) is too high
E097 Discharge current at
output (DC) is too high
E101 Current measurement
error (AC)
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Perform a restart. If the error has not been
corrected, contact your dealer to arrange a
service.
Contact your dealer to arrange a service.
Contact your dealer to arrange a service.
Contact your dealer to arrange a service.
Recharge the LPS.
Recharge the LPS.
Stop charging the LPS so that the cells
equalise. Contact your dealer if the warning
is still displayed after 24 hours.
Ensure a warmer ambient temperature.
Ensure a cooler ambient temperature.
Recharge the LPS.
Increase the DC input voltage (12 V).
Reduce the DC input voltage (12 V).
Contact your dealer to arrange a service.
Contact your dealer to arrange a service.
Contact your dealer to arrange a service.
Disconnect or regulate the power source at
the DC output (12 V).
Disconnect or regulate the power source at
the DC output (12 V).
Contact your dealer to arrange a service.
Page 23 of 25
Troubleshooting
Solution