Lk Programming - Assa Abloy SARGENT Profile LK Series Programming Instructions Manual

Keypad

Hide thumbs

Table Of Contents

Keypad Programming Instructions for the Profile Series LK Lock

LK Programming (100 Users)

To determine programming steps for your lock:

Change the Master Code

99# 1234*

Yellow LED blinks

50# 1#

Yellow LED blinks

New Master Code*

Yellow LED blinks quickly

New Master Code*

Yellow LED blinks slowly

Yellow LED goes out (If solid, see note)

This example uses the Factory Default 1234*

It is recommended not to use the factory default master code.

To Enter the Emergency Code

99# Master Code*

50# 02#

Emergency (1-6 digits)*

Emergency Code defaults to a 10 second unlock time and will override a thrown deadbolt on a mortise lock.

To Enter or Change the Supervisor Code

99# Master Code*

50# 1# 03#

Supervisory (1-6 digits)*

Enter A User Code

99# Master Code* or Supervisory Code*

50# 1# (User Number 04-100)#

User Code (1-6 digits)*

Enter A Passage (Maintained) Code

99# Master Code*

50# 0# (User Number 04-100)#

User Code (1-6 digits)*

Enter a Lock Out User Code

99# Master Code*

50# 3# (User Number 04-100)#

User Code*

The "Lock Out" user is location dependent — all users above the chosen user number location are locked out of the

keypad. To ensure that all users except Master, Supervisor and Emergency are locked out, program this user at

user number location "04".

800-810-WIRE (9473) • www.sargentlock.com • A7857A

• If your controller has an LK label,, use the programming below.

• If your controller has a "G1.5" label and a keypad, refer to Section 3;

• If your controller has a "G1.5" label and no keypad refer to Section 4.

• If your label has a G1-LU, G1-PK, G1-PA, G1-TU, G1-TP or G1-TA; refer to

Keypad Programming Instructions A7716 at www.sargentlock.com

Yellow LED blinks

Yellow LED blinks quickly