Chain Programming - Assa Abloy SARGENT Profile LK Series Programming Instructions Manual

Keypad Programming Instructions for the Profile Series LK/v.G1.5 Lock
5

Chain Programming

When programming multiple User Numbers and Codes into the LK or G1.5 with keypad, it is not necessary to leave
and re-enter the programming Mode (50) for each entry. Multiple entries may be chained together and the three
different types of user codes (Standard, Passage and One Time) may be mixed.
The format to be used is as follows:
"T" is the Type of user code with "1" Standard, "2" Passage and "3" One Time.
"UN_" is User Number (04-99)
"UC_" is User Code (2 to 6 digits) which correlates with the User Number
99# Master or Supervisor Code* 50# Type# User Number a# User Code a*
User Code a* T# UNb# UCb* UCb* T# UNc# UCc* UCc* ...... T# UN_# UC_* UC_**
An example with four user codes is shown below:
Type User Number
1
3
2
1
Using Master Code 4732 and above information, the lock would be programmed as follows:
99# 4732* 50# 1# 05# 875* 875* 3# 12# 2226* 2226* 2# 08# 5444* 5444* 1# 50# 3367* 3367*
If all user codes are type 1, it is not necessary to enter the type number with each entry.
The format now simplifies to:
99# Master or Supervisor Code* User Number a# User code a* User Code a* UNb# UCb* UCb* UNc# UCc*
UCc*....... UN_# UC_* UC_**
An example with three user codes is shown below:
Type User Number
1
1
1
Using Master Code 45988 and above information, the lock would be programmed as follows:
99# 45988* 07# 77* 77* 15# 67832* 67832* 91# 7568* 7568**
To chain the User Number delete procedure:
99# Master Code* User Number a#** UNb#** UNc#**....... UN_#****
Using the information from the above example:
99# 45988* 07#** 15#** 91#****
10
800-810-WIRE (9473) • www.sargentlock.com • A7857A
User Code
05
12
08
50
User Code
07 77
15 67832
91 7568
875
2226
5444
Comm Enable
Push Button
3367
+
- G1.5 - PA
Label indicates version
-
+
+
-
of electronics
+
-
-
+
+
-