Table of Contents
Advertisement
Centralized Controller
wired controller in the control system (only use CN3 or CN4, and the other
one will not be connected), there's no the sequence and the importance for
the wired controller. The series number in the figure is only for the sake of
clarity.
(3) There is a 2-bit DIP switch on the main board of wired controller SWC-02. As
for the last #36 wired controller in the control system, the 1-bit and the 2-bit of
the DIP switch should be manually pulled to position "on" and position "off"
respectively. The DIP switches of other wired controllers should be kept at
the initial ex-factory status (1-bit and 2-bit are set at position "off")
(4) As for the complete control system, the distance from the long-distance
central controller to the communication cable of the last communication node
should be less than 500m.
Note:
UNI SPLIT units and MULTI VARIABLE units can be mixed to connected with
centralized controller. The quantity is less than 36
3.3
Installation Procedure
Figure 3-9 Installation Diagram
Advertisement
Table of Contents
