Emergency Switch Guard - Pro-face GP2000H Series User Manual

3.2.2 Emergency Switch Guard

Attaching the Emergency Switch Guard
Prevent the Emergency Switch from accidentally turning ON (for example, if the
GP is dropped or placed upside down on a desk) by installing the Emergency
Switch Guard, as follows:
1. Locate the two Emergency Switch At-
tachment Screws (2 "Binding type"
screws - M3 x 8).
Do not confuse these screws with the
CF Card Interface Guard Attachment
Screws.
2. Peel off the two Emergency Switch
Guard hole covers, located next to the
Emergency Switch.
3. Align the screw holes of the Emergency
Switch Guard with the two Emergency
Switch holes.
4. Insert and tighten the attachment screws
to attach the Emergency Switch Guard
to the GP unit.
Do NOT use excessive force, which may damage the GP unit. Use a
torque of only 0.5 N•m to tighten the screws.
The GP2000H unit with the Emer-
gency Switch Guard attached will
look like the diagram on the right.
GP2000H Series User Manual
Chapter 3 – Handling and Wiring
Emergency Switch Guard
Hole Covers
3–5