Interface / Switch Guards; Cf Card Interface Guard - Pro-face GP2000H Series User Manual

Chapter 3 – Handling and Wiring
3.2

Interface / Switch Guards

This section explains how to install the CF Card Interface Guard and Emergency
Switch Guard included in the GP2000H Series unit's packing box.

3.2.1 CF Card Interface Guard

Attaching the CF Card Interface Guard
Attach the guard as follows, to meet the NEMA#250 TYPE4X/12
requirements. (Even if the CF Card Interface Guard is not attached, the protection
level of the gasket will not deteriorate as long as the CF Card Cover is closed.)
1. Locate the two CF Card Interface Guard
Attachment Screws (2 "Binding type"
screws - M3 x 8).
Do not confuse these screws with the
Emergency Switch Attachment Screws.
2. Secure the CF Card Cover onto the rear
of the GP unit. Position the CF Card
Interface Guard with the two screw
holes on the side of the CF Card Cover,
then insert and tighten the screws. (The
screws can be tightened or loosened
with a screwdriver or the side of a coin.)
Do not use excessive force, which may damage the GP unit. Use a torque
of only 0.5 N•m to tighten the screws.
The GP2000H unit with the CF Card
Interface Guard attached will look
like the diagram on the right.
*1 Units that are Revision A or later correspond to a NEMA#250 TYPE4X/12 rating. For
a description of how to identify your unit's revision code, see Page 13.
3–4
*1
environment
GP2000H Series User Manual