Quantum ATL StackLink Installation Instructions Manual page 10

Quantum|ATL StackLink™ Installation Instructions
Document 6421009-03, Ver. 3, Rel. 0
November 2001
Figure 6 Securing the
Bottom Mounting Tray
Assembly to the Rack
10
Replace the six screws and washers you removed in
3
finger-tighten them. Position the front and rear screws as far apart
as the slots allow. Position the third screw approximately in the
middle slot.
Do not over-tighten the screws. You need to be able to
Note:
extend or retract the rear support arms slightly as you
install the bottom mounting tray assembly.
Position the bottom mounting tray assembly in the rack, referring
4
to figure 6 for the correct orientation.
Position the front and rear flanges on the bottom
Note:
mounting tray outside of the rack rails.
FRONT
Secure the bottom mounting tray assembly to the rack, using eight
5
screws (YS41803) and washers (YS40404) provided in the StackLink
kit (see figure 6).
If the rack has widely spaced mounting holes, it may not
Note:
be possible to use all four screws to secure the rear
flanges. If this is the case, one screw per side at the rear is
acceptable.
Fully tighten the six screws and washers securing the rear support
6
arms to the sides of the bottom mounting tray.
Installing the Bottom Mounting Tray Assembly
step 1 and
REAR