Quantum MKZ2 Instructions For Use

Power module

Advertisement

QUANTUM POWER MODULE MKZ2 & XKZ2
U.S. PATENT# 4,988,584
INSTRUCTIONS

INTRODUCTION

Modules MKZ2 and XKZ2 were specially designed for use with the Nikon SB24, SB25, SB26, SB27, SB28,
SB28 Euro, Canon 540EZ, and 550EX.
Module MKZ2-for use with the Quantum Battery 1/1+
Module XKZ2-for use with the Bantam Battery
Read the following instructions thoroughly before proceeding.

IMPORTANT

Do not exceed the flash manufacturers maximum allowance of consecutive full-power flashes without letting
the flash cool down for a minimum of 10 minutes. If no recommendation is given, do not exceed 36
consecutive flashes without a 10 minute cool-down period.
Instructions for:
QUANTUM BATTERY1/1+ MODULE MKZ2
1. Turn the Quantum Battery 1/1+ OFF.
2. Install the module into the flash as shown in the module location diagrams.
3. Plug the module into one of the flash outputs on the Quantum Battery 1/1+.
4. Turn the Quantum Battery 1/1+ on.
If the flash does not power-up* within one second, turn the Quantum Battery 1/1+ OFF immediately**.
Instructions for:
BANTAM BATTERY MODULE XKZ2
1. Install the module into the flash as shown in the module location diagrams.
2. Insert the plug of the module into the connector jack of the Bantam Battery.
If the flash does not power-up* within one second, remove the plug from the Bantam Battery immediately**.

NOTES:

*You can tell if the flash is powered-up by checking to see if the LCD Panel on the flash becomes active, or
by listening for the whine of the flash recycling.
**If the flash does not respond, check to see if the module is correctly oriented inside the flash. If you still
have difficulty, consult your dealer or contact us for assistance before proceding.

SECURING THE MODULE

1. Using plastic screwdriver (attached to cord) turn screw in module counterclockwise 3 turns, or until wedges
retract fully.
2. Install module into the flash in correct orientation - see figures 1 & 2.
3. Press module down firmly with finger and turn screw clockwise approximately 3 full turns, OR UNTIL
YOU FEEL SOME RESISTANCE. DO NOT OVERTIGHTEN.
4. Pull module cord gently to assure that the module is secure.
5. Optional: Secure the battery door with velcro as shown in figures 3 & 4.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MKZ2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Quantum MKZ2

  • Page 1 U.S. PATENT# 4,988,584 INSTRUCTIONS INTRODUCTION Modules MKZ2 and XKZ2 were specially designed for use with the Nikon SB24, SB25, SB26, SB27, SB28, SB28 Euro, Canon 540EZ, and 550EX. Module MKZ2-for use with the Quantum Battery 1/1+ Module XKZ2-for use with the Bantam Battery Read the following instructions thoroughly before proceeding.
  • Page 2 Follow the diagrams below for your flash model. MODULE LOCATION: Match the module to the diagram inside the flash. NIKON SB24 SB25 SB26 SB27 NIKON SB28 SB27 SB28 Euro CANON Fig. 2 540EZ 550EX Fig. 1 SECURING THE BATTERY DOOR: Use the Velcro strip provided with the module to secure the battery door.

This manual is also suitable for:

Xkz2

Table of Contents