Labeling Of The Front Panel; Fig. 6-7: Two Openings For Slide-In Strips - Bosch Rexroth IndraControl VPP 21.1 Series Project Planning Manual

6-6
Display and Operating Components

Labeling of the Front Panel

The four function keys F9 to F12 and the twelve keys of the three key
blocks "Operation" can be individually labeled by slide-in strips.
Two slide-in strips are delivered with the VPP 21. The slide-in strips
consist of plastic or laminated paper. Their height is 12 mm and their
length is approximately 240 mm. The visible cut-out height for labeling is
maximum 7 mm.
The slide-in openings for this strips are hidden by the left handle bar.
To insert the slide-in strips labeled according to your individual
requirements, proceed as follows:
1. Switch off the VPP 21.
2. Remove the four screws that retain the handle bar and are accessible
from the rear side of the housing.
3. Remove the handle bar in your direction.
4. Insert the slide-in strips from the left into the now accessible slide-in
openings.
Slide-in
opening
Fig. 6-7: Two openings for slide-in strips
5. Put the handle bar to its place and retain it with the four screws.
Ensure that the labeling is well readable.
Incorrect operation because of wrong labeling!
⇒ Wrong labeling can lead to incorrect operation. Make
sure that the labeling of the slide-in strips describes
correctly the function of every key.
CAUTION!
VPP 21.1
Einschuböffnungen.fh9
DOK-SUPPL*-VPP*21.1***-PR02-EN-P