Keysight HSA N9342C Demonstration Manual page 12

12 | Keysight | N9342C/N9343C/N9344C HSA Handheld Spectrum Analyzer - Demonstration Guide
Demonstration 5
Task planner
(continued)
Figure 5. Connect to the N934xC HSA
Figure 6. Task plan editor
Action 2: Compile task plan file (.TPF) with the free N934xC HSA PC software
Instructions for HSA
Make sure the Keysight I/O library and the N934xC HSA PC software are
correctly installed. Connect the N934xC HSA and PC via a USB cable
Run the N934xC HSA PC software
Note: In order for the Keysight I/O library to "discover" the HSA USB con-
nection, you must connect the instrument to the PC via the USB cable and
follow the "wizard" directions. Running the Keysight Connection Expert
within the I/O library may be required
Establish the connection between the PC and the N934xC HSA
Add state files into the task plan file
Note: If these state files are on the PC, you should choose media type "PC" before clicking "Add Task" button.
Figure 7. Add from the device
Figure 8. Select a state file
Keystrokes for HSA
Click the shortcut key of Keysight HSA PC software on the PC screen
– Click the connection shortcut in the toolbar as shown in Figure 5
– Select the N934xC HSA in the connect instrument dialog box
– Click "Ok"
– Click "Instruments" then "Task Plan Editor" to open the task plan editor
as shown in Figure 6
– Click "Add Task" in the task plan editor dialog box as shown in Figure 7
Note: If these state files are on the PC, you should choose media type
"PC" before clicking "Add Task" button
– Double click the "Driver C" in the "Select a state file to create a task"
dialog box as shown in Figure 8
– Double click file WCDMA_CHP.STA
– Repeat the steps from b to d to add WCDMA_OBW.STA, and WCDMA_
ACPR.STA to the task plan