Basic Settings - YASKAWA FSDrive-MV1S Instructions Manual

Basic Settings

Switch to the quick programming mode (QUICK will be displayed on the LCD screen), and then set the fol-
lowing user constants.
Refer to Chapter 3 Digital Operator and Modes for Digital Operator operating procedures and to Chapter 5
User Constants and Chapter 6 Constant Settings by Function for details on user constants.
Constant
Category
Number
A1-02
b1-01
b1-02
b1-03
C1-01
C1-02
d1-01 to
-04 and
-17
E1-01
E2-01
-4
4
Table 4.1 Required and Optional Constant Settings
Name
2: Open-loop vector control
Control method
3: Flux vector control
selection This constant is not initialized by the initialize opera-
tion.
Select the frequency reference input method.
0: Digital Operator
Reference selection 1: Control circuit terminal (analog input)
2: MEMOBUS communications
3: PLC
Select the Run Command input method.
0: Digital Operator
Operation method
1: Control circuit terminal (sequence input)
selection
2: MEMOBUS communications
3: PLC
Used to set the stopping method used when a Stop
Stopping method Command is input.
selection 0: Deceleration to stop
1: Coast to stop
Sets the acceleration time to accelerate from 0 to the
Acceleration time 1
maximum output frequency, in 1-second units.
Sets the deceleration time to decelerate from the maxi-
Deceleration time 1
mum output frequency to 0, in 1-second units.
Frequency reference
Sets the frequency reference required for multi-step
1 to 4, JOG fre-
operation or JOG operation.
quency reference
Input voltage setting Set the Inverter input voltage in 1 volt.
Sets the motor rated current in 1 A units.
These set values will become the reference values for
Motor rated current
motor protection, torque limits and torque control.
This constant is automatically set during autotuning.
: Required constant settings,
Description
: Optional constant settings
Setting Factory
Range Setting
2 or 3 2
0 to 3 3
0 to 3 3
0 or 1 1
0.0 to
60.0 s
6000.0
0.0 to
120.0 s
6000.0
0.00 to
0.00%
110.00
180 to
*
630 V
700
0.1 to
*
86.6 A
1500.0