YASKAWA FSDrive-MV1S Instructions Manual page 112

Name
Constant
Number
Display
Frequency When the frequency reference is
reference setting set on the Digital Operator fre-
method selection quency reference monitor, sets
whether the Enter Key is necessary.
o2-05
Operator M.O.P.
When set to 1, the Inverter accepts
the frequency reference without
Enter Key operation.
Operation selection Sets the operation when the Digital
when digital opera- Operator is disconnected.
tor is disconnected
o2-06
Oper Detection
Cumulative opera- Sets the cumulative operation time
tion time setting in hour units.
o2-07
Operation time is calculated from
Elapsed Time Set
the set values.
Cumulative opera-
tion time selection
o2-08
Elapsed Time Run
Description
0: Enter Key needed
1: Enter Key not needed
0: Disabled (Operation continues
even if the Digital Operator is
disconnected.)
1: Enabled (OPR is detected at
Digital Operator disconnection.
Inverter output is cut off, and
fault contact is operated.)
0: Cumulative time when the
Inverter power is on. (All time
while the Inverter power is on is
accumulated.)
1: Cumulative Inverter run time.
(Only Inverter output time is
accumulated.)
Change
Setting Factory
during
Open-
Range Setting
Operation
Vector
0 or 1 0 No
0 or 1 0 No
0 to
0 hr No
65535
0 or 1 0 No
User Constant Tables
Control
Methods
MEMOBUS
Register
Flux
loop
Vector
A A 6F4H
A A 6F5H
A A 6F6H
A A 6F7H
5-
47