Festo CPX Series Electronic Manual page 38

1. Pneumatic interfaces
Module parameters: Idle mode channel x
Function no. Access to this module parameter is made via protocol−specific functions
(see manual for field bus node).
Description Only relevant with certain field bus protocols.
Idle mode channel x:
Fault state channel x:
Note With the so−called Idle mode parametrizing, you can define the signal status
which outputs should assume when they change to the idle state (see also CPX
system manual).
This parameter is not available with all field bus protocols.
Tab. 1/7: Idle mode channel x (channel−specific)
Module parameters: Force channel x
Function no. Access to this module parameter is made via protocol−specific functions
(see manual for field bus node).
Description Force mode outputs channel x: disabled (presetting)
Force state outputs channel x: Set signal
Note The function Force enables the manipulation of signal states disconnected from
actual operating states (see also CPX system manual).
Tab. 1/8: Force channel x (channel−specific)
1−18
Hold last state
Idle state (presetting)
Set output
Reset output (presetting)
Force state
Reset signal (presetting)
Festo P.BE−CPX−EA−E N en 0405b