Current Operation; Save And Recall Operation - ITech IT6302 User Manual

Solution 3: Press
voltage value using
Note: When output in OFF mode and
keys cannot be used to adjust voltage and current.
If rotary knobs are enabled, then adjusting it will real-time to change the current
output setup without press

3.5.4 Current Operation

Solution 1: press
Enter
followed by
Solution 2: Press
current value using the knob.Press
Solution 3: Press
current value using

3.5.5 Save and Recall Operation

You can store up to 27 different operating states in memory locations 1 through 27.They are
divided to three groups, each group includes nine different setups. Each operating state
includes a constant voltage value, constant current value, maximum output voltage.
Press (Shift) +
state to non volatile memory.
Recall
Press +number 1 to 9 to recall operating state assigned to this location.
You can also use the SCPI command (*SAV, *RCL) to save and recall.
When Save operation is done,there will be a corresponding information to indicate the
successful or failed operation.While for Recall operation,only information to indicate failed
recall.
Note: The power supply doesn't support Save/Recall operation when in serial/parallel
or tracking mode.
If in serial/parallel mode and do Save/Recall operation, the VFD will display INV OPER
(invalid Operation) to remind the user of a wrong operation.
If parameters want to be recalled do not exist, the current value position on VFD will
display -----, and then resume after 2S.
V-set V-set
,then press
Esc
. Press or
Enter
to confirm.
(Local) to select channel, press
.
I-set I-set
, then press
Esc
I-set I-set
, then press
Esc
. Press or
Recall
(Save) followed by a number key to save the current operating
to move the cursor position and adjust the
Enter
to exit.
button is dark, rotary knob and up/down
I-set I-set
to move the cursor position and adjust the
Enter
or to exit.
to move the cursor position and adjust the
Enter
to exit.
19
IT6302 user manual
then enter a numerical value
USER MANUAL