Operation In The Partition Keypad Mode - Satel INT-SCR-BL Manual

4

5. Operation in the Partition Keypad Mode

The LEDs show following information:
(red color) – steady light indicates an alarm in the
ALARM
blinking indicates that an alarm was triggered in the partitio
off when alarm is cleared.
(green color) – steady light indicates that the partition to which the keypad is assigned
ARMED
has been armed. Blinking indicates countdown of the exit delay.
(yellow color) – blinking indicates that a technical problem has occurred.
TROUBLE
The signaling applies to troubles from the entire alarm system, not only from the keypad
controlled partition. The type of trouble can be checked on th
keypad controlled partition will disable the trouble signaling. Disarming the partition will
restore the trouble signaling.
Note: All LEDs may be OFF in the arming mode, depending on the control panel settings.
Informa tion on the use of the partition
The partition keypad can be programmed by means of the LCD keypad (
S H
 
TRUCTURE ARDWARE
D X D 64
the /
LOAD LOAD
Abbreviations from the LCD keypad display are shown at some of the functions.
Name – option to give an individual (16-character) name to the module. This option can be accessed
in the LCD keypad as follows: 
N
 expander selection.
AMES
Partition – assignment of the keypad to a partition selected from the list. The keypad controls this
partition.
ck feature – the option available
Lo
submenu.
D X
ck ( )/Lock feature (
LOAD
Lo
The options „Lock feature" (LCD / DLOAD64) and „Lock" (DLOADX) refer to support of the
vice (e.g. electromagnetic door lock) by means of the partition keypad. This
ac tuating de
function is made available to any user authorized to use the keypad (see:
function). Control is effected by means of the relay.
D
Lock features (
LOAD
ON if partition armed – the relay is active when the partition is armed, and inactive when the
partition is disarmed.
Note: When operating in this mode the relay will change its state automatically, if the partition is
disarmed from the given keypad. When the partition is disarmed from another keypad,
the state of the relay will change on
given partition keypad.
N time [ON time] – after the user enters the CODE and presses the
Fixed O
be a ctive for the R
Fixed ON time – OFF if door open [ON, openoff] – after the user enters the CODE and presses
the key, the relay will be active until the door is opened (the door st us control input is
isolated from the common ground
Fixed ON time – OFF if door closed [ON, closeoff] – after the user enters the CODE and
presses the
is shorted again to the common ground), however not longer than for the
lay ON time – the time period during which the relay is active. Duration of the „relay ON time" can
Re
be from 1 to 255 econds. s
keypad can be found in the user manuals of the control panels.
E

XPANDERS
program. Described below are settings and options available for programming
S
ERVICE MODE
in the LCD keypad – its activation provides access to the Lock
D 64
) – its activation provides access to the lock feature options.
LOAD
X D 64
)/Lock (
LOAD
ON .
ELAY TIME
), however not longer than for the
key, the relay will be active until the door is closed (the door status control input
SATEL
S
 expander selection) or a computer with
ETTINGS
S

TRUCTURE
)
entering the CODE and pressing the
keypad controlled partition, while
n (alarm memory). The LED goes
e LCD keypad. Arming the
S
ERV
H
 
ARDWARE
M
ASTER USERS
key, the relay will
at
R ON
ELAY TIME
R ON
ELAY
INT-SCR-BL
ICE MODE
E
XPANDERS
/U
SERS
key on the
.
.
TIME