Casio DT-X400 Series User Manual page 53

Charging Battery Pack
Use the optional AC adaptor(AD-S12500A) to supply power to the charger.
1. Plug the connector from the AC adaptor into the AC adaptor jack on the charger with the
engraved side of the connector facing upwards. Push the connector fi rmly into the jack
until it clicks into place.
2. After connecting the power cable to the AC adaptor, plug the other end of it into an
AC outlet.
3. Turn on the power switch on the side of the charger. The power LEDs on the top of the
charger light red.
4. Place DT-X400 in the charger as illustrated so that the terminals on the bottom of the DT-
X400 make contact with the power contacts of the charger. Take care not to trap objects
such as the hand strap in the charger.
The power LEDs on the top of the charger light green and Charging Status LED lights
orange.
DT-X400 Charging status LED display
Orange:
Green:
Red:
Orange fl ashing: Charging (DT-X400 cannot start up because the charge remaining in the
Precautions for Use
• Even if the battery in the DT-X400 is already fully charged, charging will begin when
you set the DT-X400 in the Ethernet cradle. It may take several minutes for the fully
charged status to be indicated.
• Water or other moisture on the power contacts could cause sparking or an electric
shock, and soiled contacts could block the connection and impair charging
functionality. To ensure safety, clean the power contacts by wiping them off with a
dry cloth or cotton bud after you disconnect the AC adapter.
• Do not unplug the AC adaptor from the charger while charging battery packs continues.
• When disconnecting the AC adapter from the mains power outlet and DT-X400, do
so by gripping the connector and not by pulling on the cord.
• When placing the DT-X400 into the charger, take care not to trap the pen cord or
hand strap in the charger. Pull the hand strap out as shown in the illustration.
• Place the Multiple Battery Charger on a fl at, level surface and take care when
placing the DT-X400 in or removing it from the cradle.
Charging
Charging complete
Standby due to battery pack error or because the ambient temperature is
outside the charging temperature range.
(Charging begins when the temperature returns to the charging temperature
range.)
battery pack is too low. Wait until the charging status LED stops fl ashing
and lights orange.)
AD-S12500A
E-51