V-R100/7000/7100 Datacap Setup Guide for the Credit/Debit/Gift/EMV Card Interface...
Content Page # I Introduction II Setup III Operations IV Reporting 12-13 V Datacap Equipment...
Datacap Electronic Payment Setup The following pages contain the setup steps for the Casio’s V-R series Android touch terminals to run electronic payment using the new Datacap hardware for both the Canadian and US markets. At the time of writing this manual Mercury Payments is the only processor running on the new Datacap hardware.
The V-R terminals need software version 4.4.2 (dated 10/13/2015) or greater loaded in order to interface to the new Datacap equipment with Mercury for electronic payment (including EMV). The V-R series software versions can be down loaded from Casio’s FTP site, please refer to the software upgrade instructions for terminals requiring at least version 4.4.2.
1. Executing the Datacap APK files – Go to the Android Home screen 2. On the Android home screen depress the File Manager icon and the following screen will appear: 3. Depress the Casio folder line and the following screen will appear...
4. Select the Datacap folder to display the APK files 5. Touch each file and install it. Once both files are completely installed, return to the Android home screen and two (2) Datacap icons will appear.
6. To setup the Datacap hardware to operate on the V-R select the Datacap EFT Setting V2.1 icon (V2.1 is the software version) and the following screen will appear: 7. The Datacap setting screen options are as follows: Use Tip Format – Checking this box will print a Tip and Total lines below the Amount line for operations accepting tips on credit cards.
No Chit Under – If a business owner does not want to issue a merchant receipt under a certain dollar amount then enter the dollar amount in this field. Anything under the amount will not generate a merchant receipt requiring a signature.
OK button to SAVE the settings and go back to the Android home screen and load the Casio Cash Register application. Under the System tab, select the DB Management icon button and the following screen will appear: 9.
10. Run the “V442 Receipt. Sql” and “Setting_EFT_Datacap.sql” files on this screen. Depress the EXECUTE button when the files are highlighted will load the software. When the operation is complete depress the BACK and then CLOSE buttons to return to the System screen and answer OK to re-start the Casio application.
Operations Once the Datacap APK and SQL files have been executed the Credit, Debit, Gift and EBT tender keys will be flagged automatically to be electronic payment tenders. There are new function keys related to Datacap operations that will appear on the function and report screens that are listed below: EFT VOID/PA –...
EFT Reporting Going to the Z TAB of the Casio application will display the following screen: Depressing the EFT Report button will display a selection screen of the various reports available with the Datacap as shown below:...
Local Totals Report – This will summarize totals by credit card type LOCAL TRANSACTION REPORT – This will print each transaction in the current batch LOCAL BATCH STATUS – This checks on status of the current batch. ...
Datacap Hardware Canadian EMV Datacap TwinTran with TwinTran 3.8X software Verifone VX-810 pin pad POS cable # 7871-00 REV.A Pin pad cable # 1332-30 Rev. Canadian Non-EMV Datacap IPTran LT or TwinTran Server & PDCs MSR(s) POS cable # 7871-00 REV A US EMV (stand-alone) Datacap IPTran LT...