Functions And Settings; Operation - ProLights VIRTUALDRAPE User Manual

8

- 3 - FUNCTIONS AND SETTINGS

3.1 OPERATION

To turn on the VIRTUALDRAPE proceed as follows:
• Connect the controller to VIRTUALDRAPE through the 5-pin signal cable that is on the back of each
LED curtain.
• Connect the power cable to the controller.
• Connect the supplied main cable to a socket (100-240V~/50-60Hz).
• Switch on the controller by the switch on the rear panel.
NOTE: To connect together many VIRTUALDRAPE you need to connect the controller of each tent via signal
cables DMX 3-pin, as shown in figure 3.
POWER IN
POWER IN
POWER IN
POWER IN
VIRTUALDRAPE
DMX IN DMX OUT LED CURTAIN
DMX IN DMX OUT
LED CURTAIN
DMX IN DMX OUT LED CURTAIN
DMX IN DMX OUT LED CURTAIN
DMX512 CONSOLE
DMX OUT
Fig.3